MTS Series 793 User Manual
Mts series 793 tuning and calibration
Table of contents
Document Outline
- Contents
- Technical Support
- Preface
- Introduction
- Tuning Procedures
- When to Tune
- Tuning for the First Time
- How To Warm Up Station Hydraulics
- How to Set Servovalve Polarity
- How to Balance the Servovalve
- How to Adjust Dither
- How to Manually Tune the Control Loop
- How to Perform Advanced Tuning Techniques
- How to Auto-Tune
- How to Manually Tune Three-Stage Servovalves
- Zero the Spool Position Signal
- How to Monitor Inner Loop Signals
- How to Use Error to Tune I Gain
- About the Cascaded PIDF Control Mode
- How to Tune a Cascaded PIDF Control Mode
- About Channel Limited Channel (CLC) Control Modes
- How to Tune a CLC Control Mode
- About Dual Compensation Control Modes
- How to Tune a Dual Compensation Control Mode
- About Tuning Filters
- How to Enable a Tuning Filter
- Calibration Procedures
- Index