MTS Series 793 - Manual (Page 121)

MTS Series 793 Tuning and Calibration Calibration Procedures 121
Chapter 3
Calibration Procedures
This chapter contains step-by-step calibration instructions for MTS Series 793
Controllers. In this manual, MTS Series 793 Controllers include FlexTest IIm/
CTC, FlexTest SE, FlexTest GT, and TestStar IIm Controllers.
About calibration
procedures for specific
controller models
For each task, instructions are provided for stand-alone FlexTest SE Controllers
and Automated Controllers.
Standalone FlexTest SE Controllers refer FlexTest SE Controllers configured
to operate in the stand-alone mode (not equipped with a PC).
Automated Controllers refer to controllers equipped with MTS Series 793
Software. This includes FlexTest IIm/CTC, automated FlexTest SE, FlexTest GT,
and TestStar IIm Controllers.
Note Automated FlexTest SE Controllers are equipped with a PC in which
Exclusive Control is assigned to Station Manager. For more information
about Exclusive Control, see the FlexTest SE Users manual.
Note Because of hardware variations and optional features, some of the steps
in the procedures may not apply to your specific controller model. Steps
that apply only to specific models and options are qualified.
Where to find control
descriptions for specific
controller models
For a description of the specific calibration controls displayed on the front panel
of stand-alone FlexTest SE Controllers, see the FlexTest SE Users manual.
For a description of the specific calibration controls displayed in MTS control
software included with Automated Controllers, see the MTS Series 793 Control
Software manual. This pertains to FlexTest IIm, automated FlexTest SE, FlexTest
GT, and TestStar IIm Controllers.