MTS Series 793 - Manual (Page 161)

Force Sensor Calibration
MTS Series 793 Tuning and Calibration Calibration Procedures 161
Note Sensor calibration and range information can be edited on the Sensor
tab, located on the Station Setup window Inputs panel.
See “How to Create a Sensor File” in Chapter 2: Station Manager of the
MTS Series 793 Control Software manual.
Conditioner calibration
values
For force sensor calibration, set the following initial conditioner calibration
values.
C ONTROL S ETTING
Polarity Normal
Pre-amp Gain 250
480 (for Model 493.25 conditioner)
Post-amp Gain 2
1 (for Model 493.25 conditioner)
Total Gain 500
Excitation 10 volts
Fine Zero 0
Zero/Balance 0
Delta K (Gain/Delta K calibration
only) 1