Lenze E94AYCER - Manual (Page 8)

1 About this documentation
1.3 Terminology used
8
Lenze · E94AYCER communication module (PROFINET®) · Communication Manual · DMS 9.0 EN · 12/2013 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1.3 Terminology used
Term Meaning
Drive Lenze inverters of the "Servo Drives 9400" product series
Inverter
Standard device
Code
Parameter which serves to parameterise and monitor the drive. In normal usage,
the term is usually referred to as "Index".
Subcode If a code contains several parameters, they are stored in so-called "subcodes".
This manual uses a slash "/" as a separator between code and subcode
(e.g. "C00118/3").
In normal usage, the term is also referred to as "Subindex".
»Engineer« PC software from Lenze which supports you during engineering
(parameterisation, diagnostics, and configuration) throughout the entire life
cycle, i.e. from planning to maintenance of the commissioned machine.
FW Firmware
HW Hardware
IO controller PROFINET master
The IO controller takes over the master function for data communication of the
decentralised field devices. The IO controller is usually the communication
interface of a PLC.
IO device PROFINET slave
IO supervisor Engineering and diagnostics tools
The IO supervisor can access process data, diagnostic data, and alarm data.
Lenze setting Default settings of the device, preconfigured ex works.
Basic setting
PROFINET® (Process Field Network) is a real-time capable fieldbus system based
on Ethernet.
PROFINET® is a registered trademark and patented technology licensed by the
PROFIBUS & PROFINET International (PI) user organisation.
»STEP7« / »HW Konfig« Siemens PC software for PROFINET configuration
»Primary Setup Tool«
SW
Software