beautypg.com

6commissioning – Lenze E94AYCER User Manual

Page 36

background image

6

Commissioning

6.3

Setting the station name

36

Lenze · E94AYCER communication module (PROFINET®) · Communication Manual · DMS 9.0 EN · 12/2013 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

In the »Engineer« the station name is set under the Settings tab.

The station name is written to code

C13899

/

C14899

.

In the Lenze setting a deleted name is displayed. The name is also deleted if the "Reset to factory

defaults" command is executed by an IO supervisor or an IO controller.

How to activate changed settings in the »Engineer«:

1. Execute the device command C00002 = "11: Save start parameters".
2. Carry out a "Reset node" of the node, or switch the voltage supply of the communication

module off and then on again