ETC Alex M Alex MX - Manual (Page 28)

Preheating Providing stationary lighting
– 28 –
Alex M
030430-150B
Alex_M_E_150C_A5.doc
Setting the same preheat intensity for all dimmer channels
1 Press
[Page] to call menu page 2,
Parameters.
2 Use the knob to move the selection
cursor to the ALL input field.
3 You can set the same values here for
all channels for the following:
− Preheat (PRE)
− Intensity limit (LIM)
− Dimmer curve (DCU)
Fig. 15: Setting the same preheat
intensity for all channels
4 Turn the knob until ALL PRE appears.
• The currently set preheat intensity value is highlighted (5.0 in the figure).
5 Press [Edit] and use the knob to set the desired preheat intensity value.
The preheat intensity can be adjusted in 0.1% steps in the range from 0 to 10%.
Above 10% you can change the value in 1% steps.
6 Press [Save] to save the currently selected preheat intensity value for all
channels.