ETC Alex M Alex MX - Manual (Page 27)

Providing stationary lighting Preheating
Alex M
030430-150B
Alex_M_E_150C_A5.doc
– 27 –
Preheating
Setting preheating individually for each dimmer channel
The preheat intensity can be adjusted in 0.1% steps in the range from 0 to
10%. Above 10% you can change the value in 1% steps.
1 Press [Page] to call menu page 2,
Parameters.
2 Use the knob to move the selection
cursor to the PRE row and to the
desired channel in this row.
3 Press [Edit] and use the knob to set the
desired percentage for the preheat
intensity (
15% in the figure).
• The setting takes effect immediately.
Value range:
0 to 30%
Fig. 14:
Setting the preheat intensity value
4 Press [Save] to save the currently selected preheat intensity.
Set preheat intensity values are constantly output to the corresponding
channels but do not appear in the bar chart on menu page 1, Intensities.