ETC Alex M Alex MX - Manual (Page 22)

Basic settings Working with Alex M
– 22 –
Alex M
030430-150B
Alex_M_E_150C_A5.doc
Assigning each channel an individual DMX address
1 Press [Page] until menu page 4, Basic
Settings, appears.
2 Turn the knob until the DMX ADDRESS
field is highlighted.
3 Press [Edit].
4 Turn the knob counterclockwise until
the SINGLE setting appears.
5 Press
[Save].
Fig. 8: Basic Settings menu
Active
field: DMX ADDRESS
Selected: SINGLE
• The setting SINGLE is saved, and the next line is highlighted.
6 Press [Page].
• The field for entering addresses
individually appears.
7 Use the knob to highlight a channel,
and then press
[Edit].
8 Use the knob to set the DMX address.
9 Repeat this procedure for each of the
twelve channels.
Fig. 9: Entering addresses
individually
The LINEAR field in the lower left corner of the display allows you to enter
a start address as of which the channels receive addresses in ascending
order. This entry thus corresponds to the method described in the previous
section.
Fig. 10: Appearance of menu page 1,
Intensities, when DMX addresses have
been assigned to the channels
individually.
If individual DMX adresses are assigned, the individual adresses page
(Fig. 9) appears as fifth menu page when scrolling with
[Page].