ETC Alex M Alex MX - Manual (Page 25)

Providing stationary lighting Setting the same intensity for all channels
Alex M
030430-150B
Alex_M_E_150C_A5.doc
– 25 –
Setting the same intensity for all channels
1 Press [Page] to call menu page 1,
Intensities.
2 Use the knob to select the ALL LEV
function.
• The current setting is selected (75 in
the figure).
3 Press
[Edit] and use the knob to set the
desired value. Fig. 12: ALL LEV function
• The setting takes effect immediately and is displayed in the form of a
transparent bar with a numeric value for each channel. Value range: 0 to FF
(0% to 100%).
4 Press [Save] to save the setting.
If you find that you are unable to go below a certain value when
changing the output level, it may be because:
• At least one stored preset or chase is activated (see menu page 3,
Memory/Chaser, on page 46)
• Mem/Chase is not selected as the signal source. Example:
− Selected signal source: DMX
− Selected response in the event of a DMX failure: preset 2
− No DMX signal
º The stored preset 2 is thus active.
Output level values that are determined by activated presets can be
increased by making settings on menu page 1, Intensities, but never
reduced (HTP principle: highest takes precedence).
Similarly, intensity values that are determined by an external signal
source can also only be increased but never reduced. External
intensity values are shown on menu page 1, Intensities, by means of
solid bars.