Brother PR-600 - Manual (Page 96)

If the Thread Breaks or the Bobbin Thread Runs Out While Embroidering 77
3
If the Thread Breaks or the Bobbin Thread Runs Out While Embroidering
If the thread breaks or the bobbin thread runs out while embroidering, the machine will automatically stop.
Since some stitches may be sewn with only one thread, go back through the stitching to a point where stitches
have already been sewn before continuing embroidering.
Note
● Be careful when going back or forward
through the stitching since the embroidery
frame moves at the same time.
If the upper thread breaks
1
Re-thread the upper thread. (Refer to
page 35.)
2
Touch .
X The stitch navigating screen appears.
3
Touch and to go back through
the stitching to a point where stitches have
already been sewn.
1 Each touch of this key moves one stitch back
through the stitching.
2 Each touch of this key moves ten stitches back
through the stitching.
The embroidery frame moves. Go back to the
point where stitches have already been sewn.
If the needle bar is moved back too far
through the stitching, touch or
to go forward through the stitching.
1 Each touch of this key moves one stitch forward
through the stitching.
2 Each touch of this key moves ten stitches forward
through the stitching.
4
Touch .
X The embroidering screen appears again.
5
Touch , and then press the start/stop
button to continue embroidering.
Sapphire.book Page 77 Friday, August 1, 2003 9:12 AM