Brother PR-600 - Manual (Page 190)

Using the Optional Cap Frame 171
7
5
Insert the pins on the frame-mounting plate of
the carriage into the holes in the mounting
plate of the cap frame driver.
1 Pins on the frame-mounting plate of the carriage
2 Holes in the mounting plate of the cap frame
driver
6
Tighten the two upper thumb screws.
7
While pushing in the cap frame driver toward
the machine so that it is fully inserted, tighten
the two lower thumb screws to secure the cap
frame driver.
X This completes the installation of the cap
frame driver.
■ Installing the needle plate spacer
Attach the needle plate spacer to the needle plate.
1 Needle plate spacer
1
2
1
Sapphire.book Page 171 Friday, August 1, 2003 9:12 AM