Brother PR-600 - Manual (Page 64)

Removing the Embroidery Frame and Fabric 45
2
13. Removing the Embroidery Frame and Fabric
After sewing is finished, remove the embroidery frame, and then remove the fabric from the frame.
Removing the embroidery frame
1
With both hands, grab the left and right sides
of the arms of the embroidery frame holder,
and then slightly lift up the frame.
The pins on the arms of the embroidery frame
holder should come out of the holes in the
sides of embroidery frame.
2
Pull off the embroidery frame toward you.
Removing the fabric
1
Loosen the outer frame screw.
X If the screw was tightened using a disc-
shaped screwdriver, use the included disc-
shaped screwdriver to loosen it.
2
Remove the outer frame, and then remove the
fabric.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
● When removing the embroidery frame,
make sure that the start/stop button is lit
in red. If the start/stop button is flashing
in green, the machine may start sewing.
If the machine accidentally starts
operating, injuries may result.
● When removing the embroidery frame,
be careful that the embroidery frame
does not hit any other part of the
machine.
● Do not lift up the embroidery frame
holder with extreme force, otherwise it
may be damaged.
CAUTION
Sapphire.book Page 45 Friday, August 1, 2003 9:12 AM