Brother PR-600 - Manual (Page 191)

Appendix ———————————————————————————————————————————————————————————
172
■ Preparing the mounting jig
Lower the stopper, and then attach the mounting
jig to a stable surface, such as a desk.
1
Use a Phillips screwdriver to loosen the two
screws, and then lower the stopper in the
direction of the arrow.
1 Loosen the screw so that the stopper can be
hooked onto the screw and clamped with it.
2 Loosen until the stopper moves.
3 Stopper
2
Tighten the two screws.
• Make sure that the stopper is firmly secured.
Attach the mounting jig to a stable mounting
surface, such as a desk.
3
Loosen the thumb screw for the mounting jig,
and then open the mounting bracket so that it
is wider than the thickness of the mounting
plate.
• The mounting bracket can be mounted onto
a plate with a thickness from 9 mm (3/8
inch) to 38 mm (1-1/2 inches).
4
Securely clamp the mounting bracket onto the
mounting surface, and then tighten the thumb
screw.
1 Mounting bracket
2 Mounting plate
3 Tighten thumb screw
5
Check that there is no looseness.
If there is looseness, mount the mounting jig
onto the plate again
X This completes the preparation of the
mounting jig.
Note
● Be sure that the mounting bracket is
securely clamped onto the mounting place
and that the thumb screw is firmly
tightened.
● Do not attach the mounting jig to an
unstable surface (flexible, bent or warped).
● Be careful that the mounting jig does not fall
when it is removed.
1
2
3
Sapphire.book Page 172 Friday, August 1, 2003 9:12 AM