Brother PR-600 - Manual (Page 193)

Appendix ———————————————————————————————————————————————————————————
174
4
After arranging the brim, firmly push in the
cap as far as possible.
5
Close the clamping frame, and then hook the
catch of the snap lock to temporarily secure
it.
1 Catch of the snap lock
2 Clamping frame
Check for the following conditions.
1 The centerline of the cap is parallel with
the short side of the clamping frame.
2 The line on the left side of the cap cannot
be seen within the clamping frame.
3 The teeth on the inside of the clamping
frame cleanly grab the base of the brim.
4 The centerline of the brim holder and the
center line of the cap must make a single
straight line.
1 Teeth on the inside of the clamping frame
2 Centerline of brim holder
Memo
● If the cap fabric is thick and the clamping
frame cannot be closed, or if the fabric is
thin and the cap is too loose within the
frame, adjust the clamping frame.
6
While pulling the cap down with one hand,
pull the lever of the snap lock to securely
close it.
1 Lever of the snap lock
Note
● Make sure that there are no wrinkles within
the clamping frame. Otherwise miss
alignment will occurred.
7
While again pulling on the fabric around the
cap frame to stretch it, adjust the
embroidering position.
1
2
3
4
1
Sapphire.book Page 174 Friday, August 1, 2003 9:12 AM