Brother PR-600 - Manual (Page 217)

Appendix ———————————————————————————————————————————————————————————
198
Error messages
If the start/stop button is pressed while the machine is not correctly set up or if an incorrect operation is
performed, the machine stops and informs you of the error with a buzzer and an error message. If an error
message appears, correct the problem according to the instructions in the message.
To close the message, touch or perform the correct operation, then touch . If the message
appears again, consult your nearest authorized dealer.
The needle has stopped at an
incorrect position.
Turn the handwheel so that the
mark on the handwheel is at the
top, and then touch
.
The needle bar case has
stopped at an incorrect posi-
tion.
Touch
to automatically
reset the needle bar case.
The needle bar case motor is
locked.
Touch
to automatically
reset the needle bar case.
The machine was stopped
while the needle bar case was
moving.
Touch
to automatically
reset the needle bar case.
The needle bar case cannot be
moved to its initial position.
Touch
to automatically
reset the needle bar case.
The upper thread was cut or
the thread came out the thread
tension disc or a thread guide.
The machine is not threaded
correctly.
Check that the thread is under
the upper and middle thread
guides and correctly thread the
upper thread. (Refer to
page 35.)
The bobbin thread broke or ran
out.
Check that there is thread on
the bobbin and that approxi-
mately 50 mm (2 inches) of
thread has been pulled out, and
then re-install the bobbin.
(Refer to page 19.)
A wiper error occurred.
The thread is entangled on the
wiper, remove the thread, and
then touch
.
The automatic needle-thread-
ing mechanism did not operate
correctly.
The thread is entangled in the
automatic needle-threading
mechanism, remove the thread,
and then touch
.
Sapphire.book Page 198 Friday, August 1, 2003 9:12 AM