Brother PR-600 - Manual (Page 50)

Attaching the Embroidery Frame to the Machine 31
2
1
Loosen the two thumb screws on the
embroidery frame holder.
If the screw is too tight, please use the included
disc-shaped screwdriver.
1 Left arm
2 Thumb screws
X The left arm of the embroidery frame holder
can be moved.
• Only loosen the thumb screws a maximum
of 2 turns counter clockwise. Do not remove
the screw.
2
Move the left arm to align the screw on the
right side with the mark for the embroidery
frame to be installed, and then tighten the
thumb screws.
For this example, align with mark 5.
1 Mark for extra-large embroidery frame
2 Mark for large embroidery frame
3 Mark for medium embroidery frame
4 Mark for embroidery frame for industrial
embroidery machines (When using embroidery
frames for industrial embroidery machines, THE
MACHINE DOES NOT RECOGNIZE THE
SEWING AREA OF THE FRAME. Be sure to use
the trial sewing function to check that the pattern
fits within the sewing area. If an embroidery
frame for an industrial embroidery machine is
installed, the right arm of the embroidery frame
holder must also move. For details, refer to
page 168.)
5 Mark for small embroidery frame
6 Align the screw with the mark.
Note
● Please firmly tighten the two thumb screws
with included disc-shaped screwdriver. The
machine will recognize the wrong frame size,
if the two screws are not tightened.
X The embroidery frame holder is ready for
the embroidery frame to be attached.
3
Hold the embroidery frame level, and then
simultaneously align both the left and right
mounts with the embroidery frame holder clips.
• The inner frame should be on top.
Note
● Incorrect frame positioning.
4
Insert the embroidery frame until it snaps into
place.
1 Make sure that the pins on the left and right arms
of the embroidery frame holder fit into the
positioning slot and hole on the embroidery frame.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
2
1
6
1 2 3 4 5
1
Sapphire.book Page 31 Friday, August 1, 2003 9:12 AM