Brother PR-600 - Manual (Page 94)

Changing the Thread Spools with Designs of Seven or More Colors 75
3
Changing the Thread Spools with Designs of Seven or More Colors
This section contains details on understanding the change thread spools message and on easily changing the
thread spools.
Change thread spools
message
When it is necessary to replace the thread spool
while embroidering a pattern that contains seven or
more colors, the machine automatically stops sewing
and the message shown below appears. This
message also appears when it is necessary to change
the thread spools before beginning to embroider a
new pattern. Change the thread spools according to
their new assignments.
1 The needle bars where the thread spools must be
changed appear in color.
2 The needle bars where it is not necessary to
change the thread spools appear in gray.
3 Touch this key to close the message indicating
that the thread spool be changed.
Note
● When the embroidering screen is displayed,
the current thread color assignment is
stored. If the same thread color is used the
next time that the thread spools must be
changed, the needle bar will be assigned
the same thread color as before.
Memo
● To use a different thread color than the one
that was specified, use temporary needle
bar setting key, and then change the thread
color setting. (For details, refer to
“Temporary Needle Bar Setting” on
page 92.)
● To minimize changing the thread spools,
frequently used thread colors can be
specifically assigned to certain needle bars.
(For details, refer to “Reserved Needle Bar
Settings” on page 94.)
Sapphire.book Page 75 Friday, August 1, 2003 9:12 AM