Brother PR-600 - Manual (Page 49)

EMBROIDERING TUTORIAL ———————————————————————————————————————————————————
30
8. Attaching the Embroidery Frame to the Machine
After hooping the fabric in the embroidery frame, attach the frame to the embroidery machine.
Note
● Before attaching the embroidery frame, check that there is enough thread in the bobbin.
Attaching the embroidery frame
Adjust the width of the embroidery frame holder to the size of the embroidery frame, and then attach the
embroidery frame to the machine. As an example, the procedure for attaching the small embroidery frame is
described below.
● If the embroidery frame is not correctly attached, the embroidery frame may hit the presser
foot, resulting in injuries.
● When attaching the embroidery frame, make sure that the start/stop button is lit in red. If the
start/stop button is flashing in green, the embroidery machine may start sewing. If the
embroidery machine accidentally starts operating, injuries may result.
● When attaching the embroidery frame, make sure that the embroidery frame does not hit any
other part of the embroidery machine.
CAUTION
Positioning slots
Embroidery frame Holes
Left arm of embroidery frame holder
Move the arm of the embroidery frame holder to the left or
right to adjust it to the size of the embroidery frame.
Positioning Pin
Clip on embroidery frame holder.
Insert the embroidery frame into the clips
on the embroidery frame holder.
Sapphire.book Page 30 Friday, August 1, 2003 9:12 AM