Brother PR-600 - Manual (Page 180)

Helpful Tips for the Operation of PR-600 161
7
6
Touch (unlock key), and then press the
start/stop key to begin embroidering.
7
Correct thread tension. From the wrong side
of the fabric, the bobbin thread should be
about one third of the stitch width.
Note
● If adjustment is necessary, refer to
instructions on page 44 or 83/84.
Sewing a pattern aligned with
a mark on the fabric
By specifying the beginning of stitching and the end
of stitching, the exact position of the pattern can be
checked.
For example, when sewing text along a line in the
fabric pattern, the beginning of the stitching can be
set in the lower-left corner so that the position can be
checked, and then the beginning of stitching can be
reset. Next, the beginning of stitching can be set in
the lower-right corner to check the position. The
straight line connecting the first point and the second
point is the baseline for the text. If the baseline that
the text follows leaves the fabric pattern, the
embroidering position can be adjusted.
1
Touch in the embroidering settings
screen.
2
Set the beginning of stitching in the lower-left
corner.
X The frame moves so that the needle drop
point aligns with the beginning of stitching.
Sapphire.book Page 161 Friday, August 1, 2003 9:12 AM