Brother PR-600 - Manual (Page 109)

Embroidering Settings ——————————————————————————————————————————————————————
90
Setting the Machine to Stop at Color Changes
The machine can be stopped at any time; however, if the machine is stopped while it is embroidering, it is better
to go back a few stitches before continuing sewing to overlap the stitching. If the machine stops at a color
change, it is not necessary to go back through the stitching before continuing embroidering.
Stopping the machine at the
next color change
The machine can be set to stop before sewing the
next color.
1
While sewing the color before the point
where you wish to stop the machine, touch
so that it changes to .
2
After finishing sewing the area for the current
color, the next needle bar moves into position
and the machine stops before sewing the next
color.
X changes back to .
•
I
f the machine is temporarily turned off, you
will be asked if you wish to continue sewing
or select a new pattern when the machine is
turned on again.
Touch to continue embroidering.
(Refer to “Resume Embroidering After
Turning Off the Machine” on page 81.)
Specifying pause locations
before embroidering
Pause locations can be specified in the change
thread color screen, displayed by touching .
1
Touch in the pattern editing screen or
the embroidering settings screen.
X The change thread color screen appears.
2
Touch and so that the color at
the top of the thread color sequence display is
the color where you wish to stop the machine
before sewing it.
Sapphire.book Page 90 Friday, August 1, 2003 9:12 AM