Brother PR-600 - Manual (Page 196)

Using the Optional Cap Frame 177
7
4
Remove the cap frame driver.
Note
● Be careful that the cap frame driver does not
hit any nearby parts, such as the presser
foot.
5
With the hole on the sweat guard holder
aligned with the centerline of the guiding
plate, insert the two thumb screws removed in
step
3
into the holes at the top, and then
tighten the thumb screws.
1 Hole on the sweat guard holder
2 Centerline of guiding plate
3 Holes on the top
• Insert the thumb screws into the holes where
the cap frame driver that was originally
installed (holes that the thumb screws were
removed from in step
2
on page 170).
X The movable section of the cap frame driver
is secured.
6
Align the holes on the embroidery frame holder
with the pins in the frame-mounting plate of the
carriage.
1 Pins in the frame-mounting plate
2 Holes on the embroidery frame holder
7
Secure the embroidery frame holder with the two
thumb screws.
1 Use the thumb screws included with the machine
(thumb screws removed in step 1 on page 170).
2
1
3 3
● Using the disc-shaped screwdriver
included, firmly tighten the thumb
screws.
1
2
CAUTION
Sapphire.book Page 177 Friday, August 1, 2003 9:12 AM