Xerox 4112-4127 Enterprise Printing System-4611 - Manual (Page 27)

Setups
Xerox 4112/4127 EPS 3-11
System Administration Guide
Power Saver/Energy Saver Timers
This machine provides a Power Saver mode used to reduce power consumption when the
machine is inactive.
In power saving mode, there is a Low Power mode and a Sleep mode. When the set time has
elapsed, these modes are switched to in the following sequence:
Last operation on the machine J Low Power mode J Sleep mode
To activate the Power Saver feature, set the Sleep Mode button to Enabled, and set the Low
Power mode and the Sleep mode time intervals using the following procedure.
Note
The amount of time that passes before the machine enters Low Power mode and Sleep
mode can be specified in 1 minute increments, from 1 to 240 minutes for each mode.
1. From the Machine Clock/Timers screen, select Power Saver / Energy Saver Timers, and
select Change Settings.
2. Using the , configure a power saver mode migration time in 1 minute increments for
Low Power mode and Sleep mode.
• From Last Selection to Low Power Mode: Set the time to go from last operation to Low
Power mode.
Note
The time From Last Operation to Low Power Mode cannot exceed the time From Last
Operation to Sleep Mode. The default is 15 minutes.
• From Last Selection to Sleep Mode: Set the time to move to the Sleep Mode after
the last operation.
Note
The default for From Last Selection to Sleep Mode is 60 minutes. Configure the From Last
Selection to Sleep Mode time to be longer than the From Last Selection to Low Power
Mode time.
3. Select Save to save the settings and return to the previous window.