Xerox 4112-4127 Enterprise Printing System-4611 - Manual (Page 25)

Setups
Xerox 4112/4127 EPS 3-9
System Administration Guide
1. From the Machine Clock/Timers screen, select Auto Clear and select Change Settings.
2. Select Off or On.
3. If you selected On, set the time by using the , , or the numeric keypad to enter a
numeric quantity.
If you selected Off, you must exit System Administration mode for the system to return to
the default screen.
4. Select Save to save the settings and return to the previous window.
Auto job release
If an error occurs during a print job, you can set the time that elapses until the current job is
automatically cleared, and thereby enables the completion of the next job. Errors that may
occur include a paper jam, the machine runs out of hard disk space, etc. Once the current job is
cleared, jobs that can be continued are limited to those that only use parts of the machine not
affected by the error.
Set the value in the range 4 to 99 minutes, in 1 minute increments.
1. From the Machine Clock/Timers screen, select Auto Job Release, and select Change
Settings.
2. Select Off if you do not want to use this feature.
3. Select On to set the elapse time by using the , , or the numeric keypad to enter a
numeric quantity.
4. Select Save to save the settings and return to the previous window.