Konica Minolta BIZHUB PRO 1050 - Manual (Page 9)

1
Introduction
1-1 bizhub PRO 1050
1 Introduction
Thank you very much for purchasing the bizhub PRO 1050.
This User's Guide describes the operating procedures and safety precau-
tions of the bizhub PRO 1050 so that you can handle it safely and make the
best of its capabilities. Usually keep this manual close at hand for the conve-
nience of reference later.
FCC Regulation
Warning:
This equipment has been tested and found to comply with limits for a Class
B digital device, pursuant to part 15 of FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
area.
This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following mea-
sures:
x Reorient or relocate the receiving antenna.
x Increase the distance between the equipment and the receiver.
x Connect the equipment to an outlet on a circuit other than the circuit to
which the receiver is connected.
x Consult your dealer or an experienced radio/TV technician for help.
Canadian Department of Communications Regulations
This Class B digital apparatus complies with Canadian ICES-003.
Copier
Print Controller
For use as a network printer
For use as a local printer