Konica Minolta BIZHUB PRO 1050 User Manual
Page 387
14
Utility Tool
14-41
bizhub PRO 1050
Setting Up a DEC ULTRIX 4.3 RISC or OSF1 Remote Printer
Use the following procedure to set up a remote printer on the host that sends
jobs to the network interface card.
1
At the prompt, type: lprsetup, then select [add].
2
Enter a name for your printer, then press [Enter].
3
"Do you want more information on specific printer types?" Press Enter.
A list of ULTRIX-supported printers is listed.
4
Type: remote, and press [Enter].
5
Enter a printer synonym (alias) and press [Enter].
6
Designate a spooler directory and press [Enter], or accept the default
spooler directory displayed and press [Enter].
7
Designate a remote system name and press [Enter].
8
Designate PORT1 as the remote system printer name and press [En-
ter].
9
You are asked to enter the name of a printcap symbol from a displayed
list. Type: Q, and press [Enter].
10
Your configuration is displayed.
You are asked whether these values are final. Type: Y or N, and press
Enter. An example is shown below.
11
Add comments to the printcap file. For example, you can type:
Lois' printer down the hall
12
Select exit to save your configuration, then press [Enter].
You are now prepared to print.
Printer #7 Symbol
Type
Representative Value
lp (line printer)
STR
rm (remote host)
STR
Network Interface Card_host
rp (remote printer)
STR
PORT1
sd (spooler directory)
STR
/usr/spool/lpd7