Konica Minolta BIZHUB PRO 1050 - Manual (Page 328)

12
Troubleshooting
12-4 bizhub PRO 1050
12.3 General Problems of PostScript
A PostScript Error message displays.
A search can be made from [http://support.adobe.com/devsup/devsup.nsf/
main.html].
PostScript Error messages such as “VMerror” and “limitcheck” display.
The printer (copier) may be short on memory capacity. Consider upgrading
the memory.
A PostScript Error message displays when attempting to get a printout
from any computers are in use.
There may be loose connections in the printing system. Recheck all of con-
nections.
A PostScript Error message displays when attempting to get a printout
from a specific application.
Error conditions may exist in the application. Try to print out a simple test file.
If this also does not succeed, reinstall the application in question.
A PostScript Error message displays when attempting to get a printout
from a specific file.
It is possible that the print setting for the file is wrong, that graphics con-
tained in the file are damaged, or that bad elements are contained in the file.
Find a print setting that does not cause any PostScript Error message to ap-
pear, and try to get a printout. If this fails, save the file as a new file.
A PostScript Error message displays when attempting to get a printout
of a specific page.
It is possible that elements or fonts used in the page are damaged, or a larger
memory capacity than currently available capacity is needed for the printout.
Try to print with specifying one element or font of the various ones in the
page. If this trial causes no problems, consider upgrading the memory.
Fonts cannot be downloaded.
It is possible that [Spool] is set to [On] in Printer Setting Menu on the copier’s
control panel.
Set [Spool] to [Off], switch off the copier’s main power, wait 10 seconds or
more, switch it back on, and then try downloading fonts again.
For details on how to download fonts, refer to the User’s Guide that comes
with the fonts.