Konica Minolta BIZHUB 223 - Manual (Page 34)

bizhub 423/363/283/223 4-4
4.2 Easy installation procedure using the installer 4
4
When a page for selecting menu to setup appears, select [Install printers/MFPs], and then click [Next].
Connected printers and MFPs are detected.
% For Windows Vista/Server 2008/7, you can select [Preference for IPv4] or [Preference for IPv6]. If
the printer/MFP is detected using both IPv4 and IPv6, the selected address is prioritized.
% If no printer is detected, turn this machine off, then on again.
In this case, turn off this machine, and then wait approximately 10 seconds before turning it on
again. If you turn this machine on immediately after turning it off, it may not function correctly.
5
Select this machine, and then click [Next].
% Of the connected printers or MFPs, only the models that support the printer driver are displayed in
the list. If multiple target models are displayed, check the IP addresses.
% If the connection to this machine cannot be recognized, it is not displayed in the list. If this is the
case, select [Specify the Printer/MFP Except for the Above. (IP Address, Host Name...)] on the lower
part of the page, and then specify your printer manually.
% As a printing method, you can select [Normal Printing] (Port9100, USB), [Internet Printing] (IPP), or
[Secure Printing] (IPPS). Note that [Secure Printing] (IPPS) is available only when SSL is enabled for
PageScope Web Connection and IPP is enabled.
% In Windows Vista/Server 2008/7, you cannot set up [Secure Printing] (IPPS connection) using the
installer. To use IPPS connection, use the Add Printer Wizard. For details, refer to page 5-8.
% Windows Vista/Server 2008/7 supports both IPv4 and IPv6 environments, however, it does not sup-
port [Internet Printing] (IPP) in the IPv6 environment.