Pulsafeeder Pulsar DLC - Manual (Page 55)

50
v
Level/Start-Stop Set Up Procedure
1. Press [MENU] to enter the { –MENU – } sub-system. Press [UP] or [DOWN] until { –MENU– /
LEVEL SWITCH} screen is displayed.
-MENU-
LEVEL SWITCH
Press [ENTER] to continue to program the Level Switch sub-menu.
2. The level input can be configured as {INACTIVE}, if it will not be used.
LEVEL SWITCH
INACTIVE
Pressing [ENTER] when {LEVEL SWITCH / INACTIVE} is displayed will cause the screen to return
to the { –MENU– / LEVEL SWITCH} screen.
3. Press [UP] to scroll to the next option {LEVEL SWITCH / ACTIVE}.
LEVEL SWITCH
ACTIVE
4. Press [ENTER] when {LEVEL SWITCH / ACTIVE} is displayed and the following screen is
displayed.
LEVEL SWITCH
DRUM LEVEL
Select this option if the level input is to be connected to a drum level switch.
Press [ENTER] to select. Go to step 7.
5. Pressing [UP] when the {LEVEL SWITCH / DRUM LEVEL} screen is displayed will open
the{LEVEL SWITCH / START/STOP} screen.
LEVEL SWITCH
START/STOP
6. Pressing [ENTER] from {LEVEL SWITCH / START/STOP} screen to configure the LEVEL
SWITCH input for use with a remote motor On/Off switch.
7. The Level Switch Configuration screen is displayed:
LEVEL SWITCH
NORMALLY CLOSED
8. Press [ENTER] to configure the switching device as {NORMALLY CLOSED}, or press [UP] and then
press [ENTER] to configure the switching device as {NORMALLY OPEN}.
LEVEL SWITCH
NORMALLY OPEN
When {LEVEL SWITCH / START/STOP} has been selected, you are returned to the {–MENU– /
LEVEL SWITCH} screen. This setting uses the default settings of {MOTOR OFF? / YES} and
{ALARM RELAY? / NO}. These settings cannot be modified.
9. The display prompts for the motor status when the Level Input trips:
LEVEL SWITCH
MOTOR OFF? YES
Press [ENTER] if you want the PULSAR motor to turn off when the Drum Level input is sensed. Go
to step 11.