Pulsafeeder Pulsar DLC - Manual (Page 103)

98
12. Note the position of the PULSAR adjustment shaft 'flats'. They mate with a slot in the DLC drive
coupling of the output shaft. The output shaft is connected to the adjustment knob. Familiarize
yourself with these mating components prior to installation (refer to Figure 27).
Figure 27 – DLC/Eccentric Mating Components
13. Locate the face on the bottom of the DLC that mates with the face of the lip of the gear box.
The DLC is normally oriented such that the control pad and display sit to the left of the pump's reagent
head (as viewed standing in front of the reagent head looking at the motor). The conduit connections
and access panel (with Serial Tag) reside at the rear of the pump near the gear box (refer to Figure 28).
Figure 28 – Installation Orientation