Pulsafeeder Pulsar DLC User Manual
Page 101
96
5. Remove the Tachometer Sensor Input Cable on the Field Wiring Board.
a) Disconnect the wire (typically brown) connected to Pin 1 of J10.
b) Disconnect the wire (typically blue) connected to Pin 2 of J10
6. Disconnect the Tachometer Sensor Conduit Assembly nut from the Tachometer Sensor Conduit
Assembly and remove the Conduit Assembly and Tachometer Sensor wire from the DLC housing.
Figure 24 – Accessing the Tachometer Sensor Conduit
O
Perform steps 5 and 6 only if there is a Tachometer installed. If there is no Tachometer installed, go to step
7 on the next page.
See also other documents in the category Pulsafeeder Pumps:
- Pulsa GLM DM1-6 (30 pages)
- Pulsa GLM DM7 (33 pages)
- Pulsa 340 (24 pages)
- Pulsa Series 200-680C (20 pages)
- Pulsa Series 680 EN (26 pages)
- Pulsar 25H (54 pages)
- Pulsar Shadow (48 pages)
- PulsaPro 900 EN (71 pages)
- Polyfeeder EN (47 pages)
- PULSAlarm (24 pages)
- Eclipse Hypopump (140 pages)
- ECO Series Back Pressure Valve Instructions (1 page)
- ECO Series Relief Valve Instructions (1 page)
- Isochem RGT IOM (44 pages)
- Pulsar Series HypoPump (15 pages)
- Pulsar Series HypoPump2 (27 pages)
- MPC (56 pages)
- MPC Vector (70 pages)
- Pulsa Series Pulsamatic Controls (34 pages)
- Pulsar DLC XP RC (68 pages)
- Pulsar DLCM (135 pages)
- Pulsar ECA NEMA4X (38 pages)
- Pulsar ECA NEMA7 (23 pages)
- Chem-Tech Series XPV EN (19 pages)
- Chem-Tech Series XP EN (22 pages)
- Chem-Tech Series XP TIMER EN (20 pages)
- Chem-Tech Series Prime Performance EN (12 pages)
- Chem-Tech Series Prime Performance EN (3 pages)
- MEC-O-MATIC VSP Series (8 pages)
- OMNI Series DC7 (34 pages)
- OMNI Series DC2-6 EN (46 pages)
- PULSAtron Series A Plus EN (16 pages)
- PULSAtron Series ET (17 pages)
- PULSAtron Series MP EN (32 pages)
- PULSAtron Series T7 (23 pages)
- Digital Glycol Feeder DGF1 (45 pages)
- Polymer Makedown Automatic Systems EN (15 pages)
- Polymer Makedown Systems EN (11 pages)
- Pre-Engineered Skid Systems (23 pages)