Panasonic MotionDV STUDIO 5.6E LE eng - Manual (Page 234)

Q&A
- 234 -
Your video device cannot be operated
Your video device cannot be operated
Your video device cannot be operated.
• Make sure the power to the video device is turned
on.
• Make sure the DV device input mode is established.
• Make sure the tape is inserted in the video device.
• Make sure the cable is connected properly.
• If the cable is connected to the AV input/output
terminal of the video device, the device cannot be
operated in some cases.
Unplug the cable from the AV input/output terminal
of the video device.
• Make sure there is nothing wrong with the video
device connected.
• Do not use functions to display the menu, etc. on the
video device. It cannot be operated properly.
• Make sure the video device connected is made by
Panasonic.
• The personal computer may be in an unstable state.
Exit MotionDV STUDIO, and then reboot the
personal computer.
No video in your video device is displayed on the
personal computer.
• Make sure the tape where video is recorded is
inserted in the video device.
• Even if you operate from the personal computer to
play the video, it may take a short while until video is
displayed on the screen of the personal computer
after the video is displayed on the video device.
• If 2 video devices are connected, check to see if the
player (input) and the recorder (output) are selected
correctly.
• The personal computer may be in an unstable state.
Exit MotionDV STUDIO, and then reboot the
personal computer.
• If the head of the video device is dirty, video cannot
be imported normally.
Use a digital video head cleaner to clean the heads.
(For details, refer to the operating instructions of the
video device.)
This section covers the solutions to troubles that often
occur when you cannot operate the video device
normally.