Allied Telesis AT-CV5000 - Manual (Page 81)

AT-CV5000 Media Converter Chassis Installation Guide
81
Resetting the Line Cards and the Module in the Rear Expansion Slot
To reset the line cards and the module in the rear expansion slot, perform
the following procedure:
1. Locate the RESET LINE/EXP button, which is recessed on the front
panel of the LED interface card.
Note
This RESET LINE/EXP button located on the LED interface card
allows you to reset the line cards in the front of the chassis and any
module in the rear expansion slot. This button does not reset any
management cards in the chassis.
2. Press the reset button with the tip of a pen or a non-conductive pointed
object, as shown in Figure 55.
Figure 55. Resetting Converteon™ Line Cards/Rear Expansion Module
FAN1
PS1
RDY
AT-CV5LED
RDY M STR F LT
RESET LINE/EXP
PS-A P S-B
FAN-A FAN-B
261
REAR
S
LO
T CON
S
OLE