Allied Telesis AT-CV5000 - Manual (Page 76)

Chapter 3: Working with Line Cards and other Modules
76
Working with the AT-CV5M01 Management Card
This section contains the following procedures:
ˆ “Installing an AT-CV5M01 Management Card,” next
ˆ “Resetting an AT-CV5M01 Management Card” on page 77
ˆ “Replacing an AT-CV5M01 Management Card” on page 78
Installing an
AT-CV5M01
Management
Card
This section describes how to install an AT-CV5M01 Management Card.
Note
The AT-CV5M01 Management Card is hot-swappable. You can
install it without powering off the Converteon™ chassis.
To install an AT-CV5M01 Management Card, perform the following
procedure:
1. Remove the AT-CV5M01 Management Card from its shipping
package and store the package in a safe place.
Note
You must use the original package if you need to return the unit to
Allied Telesis.
2. Select any line card slot in the AT-CV5000 chassis where you want to
install the management card and remove the slot cover, if installed.
3. Align the back edge of the management card with the top and bottom
alignment guides located inside the slot.
Note
Avoid touching the line card components.
Warning: Remove all metal jewelry, such as rings and watches,
before installing or removing a line card from a powered-on
chassis.
E26
Caution: Be sure to observe all standard electrostatic discharge
(ESD) precautions, such as wearing an antistatic wrist strap, to
avoid damaging the device. A line card can be damaged by
static electricity.