Allied Telesis AT-CV5000 - Manual (Page 70)

Chapter 2: Installation
70
Starting a Remote Management Session
The procedure in this section explains how to start a remote management
session using the 10/100Base-TX port on the AT-CV5M01 Management
Card on the chassis. You can use a remote management session to
configure the chassis operating parameters and view performance and
error statistics using the AT-S70 management software.
To manage a chassis remotely, you must first assign an IP address to it.
For information about assigning an IP address to the system, refer to
Chapter 1, “Getting Started,” in the AT-S70 Management Software User’s
Guide.
To start a remote management session, perform the following procedure:
1. Connect a twisted pair cable to the 10/100Base-TX port on the front of
the AT-CV5M01 Management Card, as shown in Figure 47.
Figure 47. Connecting a Twisted Pair Cable to the 10/100Base-TX Port on
the AT-CV5M01 Management Card
Note
The RJ-45 port runs in MDIX mode. Be sure to use the proper cable.
The connector and port pinouts are shown in “RJ-45 Twisted Pair
Port Pinouts” on page 103.
2. In the Telnet application, specify the IP address of the AT-CV5000
chassis that you want to access.
The software initializes and then the login prompt is displayed.
3. Press twice.
4. When prompted, enter a username and password.
ˆ To configure the chassis settings, enter “manager” as the
username. The default password for manager access is “friend”.
ˆ To just view the settings, enter “operator” as the username. The
default password for operator access is “operator”.
245
T
X
ML/SML
F
RDY
LK A
CPU RESET
LK A T FD