Allied Telesis AT-CV5000 - Manual (Page 21)

AT-CV5000 Media Converter Chassis Installation Guide
21
LED Interface Card
The LED interface card, as shown in Figure 5, is preinstalled in the
AT-CV5000 chassis and is not field-replaceable. The LED interface card
features the following components:
ˆ One RS-232 terminal port with a DB-9 connector
ˆ One recessed RESET LINE/EXP button
ˆ Seven system status LEDs
Figure 5. LED Interface Card Components
RS-232 Terminal
Port
You can use the RS-232 terminal port on the LED interface card to
establish a local connection to any module present in the expansion slot
located in the rear of the chassis.
Note
This terminal port does not connect to any AT-CV5M01
Management Card in the chassis. Each AT-CV5M01 Management
Card contains its own RS-232 terminal port, as shown in Figure 6 on
page 24.
The RS-232 terminal port on the LED interface card has a DB-9 female
connector and uses a straight-through RS-232 cable (not provided). The
default settings for the RS-232 terminal port are:
ˆ Baud rate: 115200 (range 2400 to 115200 bps)
251
FAN1
PS1
RDY
AT-CV5LED
RDY M
STR F
LT
RESET LINE/EXP
PS-A P
S-B
FAN-A F
AN-B
.
S
LO
REAR
S
LO
T CON
S
OLE
Status LEDs
Recessed RESET LINE/EXP Button
RS-232 Terminal Port