Allied Telesis AT-CV5000 - Manual (Page 60)

Chapter 2: Installation
60
Powering On an AC Powered Chassis
This section describes how to power on an AC powered AT-CV5000
chassis. If your chassis is DC powered, see “Powering On a DC Powered
Chassis” on page 64.
Note
The AT-CV5000 chassis is shipped without any power supplies
installed. You must install at least one power supply in order to
power on the chassis. For information about installing an AC power
supply, refer to “Installing an AT-PWR14 AC Power Supply” on
page 82.
Caution
The AT-CV5000 Media Converter chassis can contain two power
supplies of the same type (AC or DC) or a combination of the two
versions with the same power ratings. Make sure not to mix power
supplies with different power ratings in the same chassis.
For information on the power supply module, refer to the
documentation that is shipped with the module.
Note
The AT-PWR14 AC power supply is shipped with four power cords,
one each for North America, the UK, Europe, and Australia. Locate
the correct power cord for your location before beginning this
procedure.
To power on an AC powered chassis, perform the following procedure:
1. Make sure that the ON/OFF power switch is in the OFF position, as
shown in Figure 36.
Figure 36. ON/OFF Power Switch in OFF Position
PWR A
PWR B
B
100-2 40VA C ~
A T -CV5F
A N
B
1131
POWER
FAULT
AT-PWR1
4
POWER
FAULT
AT-PWR1
4
A
A T -CVF
AN
A
100-2 40VA C ~ WA RNIN G This un it migh t have m ore tha n one p ower in put. To
reduce the ris k of ele ctric sh ock, dis connec t all po wer
inputs b efore s ervicin g unit.
277