Allied Telesis AT-CV5000 - Manual (Page 78)

Chapter 3: Working with Line Cards and other Modules
78
Note
This CPU RESET resets only the management card, and does not
reset the line cards and/or the module installed in the expansion slot
at the rear of the chassis. You may need to reset the management
card after upgrading the firmware or after you have made a
configuration change that requires resetting the module to
implement the change.
2. Press the reset button with the tip of a pen or a non-conductive pointed
object, as shown in Figure 52.
Figure 52. Resetting the AT-CV5M01 Management Card
Replacing an
AT-CV5M01
Management
Card
When an AT-CV5M01 Management Card is replaced, all the parameter
settings saved on the management card are lost. To keep the current
parameter settings, upload the configuration file onto a TFTP server
before replacing the AT-CV5M01 Management Card. After a new
AT-CV5M01 Management Card is installed, you can download the
configuration file onto the new management card.
For instructions on how to upload and download a configuration file, refer
to Chapter 10, “File Downloads and Uploads” in the AT-S70 Software
Management User’s Guide.
AT-CV5M01
PWR R DY FL T
CPU RESET
LK A T FD
519