Allied Telesis SwitchBlade x8106 - Manual (Page 70)

Chapter 2: Safety Precautions and Site Requirements
70
Installation Tools and Material
This section lists the tools and material you need to supply to install the
product:
Here are the items for installing the chassis in an equipment rack:
 #2 Phillips-head screwdriver
 Six equipment rack screws
 Flat-head screwdriver
 #2 Phillips-head 10 inch-lbs torque screwdriver (optional)
Here are the items for installing the grounding wire:
 #2 Phillips-head screwdriver
 Crimping tool
 10 AWG stranded grounding wire
 #2 Phillips-head 20 inch-lbs torque screwdriver (optional)
Here are the items for installing the AT-SBxPWRSYS1 DC Power Supply:
 Two 8 AWG power wires
 One 10 AWG stranded grounding wire
 8 mm wrench
 #1 Phillips-head screwdriver
 #3 Phillips-head screwdriver
 #3 Phillips-head 30 to 40 inch-lbs torque screwdriver (optional)
Here are the items for installing the AT-SBx81CFC400 Controller Fabric
Card and Ethernet line cards:
 #2 Phillips-head screwdriver
 #2 Phillips-head, 5 inch-lbs torque screwdriver (optional)