Ag Leader GeoSteer Installation Manual - Manual (Page 35)

Hardware Installation Guide 25
8
Connecting System Cables
The Connecting System Cables chapter provides information in the following sections:
• Overview
• Cable Diagram Examples
• AutoSteer Valve Installation Example
• Assisted Steering Unit Installation Example
• John Deere AutoTrac Ready Installation Example
• Case AccuGuide / New Holland IntelliSteer Ready Articulated Installation Example
• Case AccuGuide / New Holland IntelliSteer Ready MFWD Installation Example
• MacDon Valve Installation Example
• CAN Bus Installation Example
• Dual CAN Bus Installation Example
• CAT Valve Installation Example
• Deere Track Installation Example
• Prepare the Cab Cable Access Point
• Attach Harnesses to GeoSteer Control Unit
• Vehicle-Specific Harness
• GeoSteer Main Cable Harness
• Coax Cables
• Power Supply Requirements
• Warning Label
Overview
The final step of the installation is to connect all the components installed with the various harnesses that come with the
system. Each vehicle is different in how the cables are routed and what components are connected. The Cable Diagram
Examples in this chapter of this manual provides some generic cable diagrams of how the GeoSteer system can be connected
on a number of different vehicle types. The Cable Diagram section in the AutoSteer Installation Manual that come with the
vehicle-specific installation kits also provide some additional detail to the vehicle-specific components that are connected.
Refer to the Display’s User Manual for additional instructions on how to connect the GeoSteer system to the Display.
Note: When routing harnesses, verify that all harnesses are routed away from moving parts and sharp objects. Secure the
harnesses with cable ties to ensure they are not damaged.