Ag Leader GeoSteer Installation Manual - Manual (Page 28)

GeoDock Installation
18 GeoSteer System
8. Once the GeoDock Mounting Plate is in the proper location, firmly press the adhesive areas to ensure a good contact is
made with the roof. Apply pressure for a few seconds to all four corners of the plate.
Note: The high bond tape uses a permanent adhesive. Verify and confirm the correct position and orientation of the
mounting plate before applying to the vehicle roof.
9. If any of the accessory kits for the GeoDock have been ordered, follow the instructions that come with the accessory kits
and install those components.
10. Place the GeoDock on the GeoDock Mounting Plate.
Note: Make sure the tabs line up between the GeoDock and the GeoDock Mounting Plate.
Figure 5-7 GeoDock Installed