Ag Leader GeoSteer Installation Manual - Manual (Page 16)

Installation Procedure Outline
6 GeoSteer System
10. GeoSteer Vehicle-Specific Harness – If the installation requires, install the GeoSteer Vehicle Harnesses. Route the
harness connections between the GeoSteer Control Unit’s right connector to all the sensors and control points on the
vehicle. If this connector is not required for the installation, verify that the dummy plug has been attached to this port to
protect the electronics. The sensors and control points on the vehicle could include any of the following:
a. Wheel Angle Sensor
b. Steering Encoder
c. Pressure Transducer
d. Flow Sensor
e. Enabler Valves
f. Steering Valve
g. Assisted Steering Unit (ex OnTrac2+)
h. Any other vehicle-specific sensor connectors
11. GeoDock Cables – Install the GeoDock to GeoSteer Control Unit cables. Verify if the following cables have been run and
connected depending on the options installed on the system (not all are required for all installations):
a. GPS Coax Cable
b. Cell Modem Coax Cable
c. Radio Modem Data/Power Harnesses
12. Final Hardware Verification – Verify that all the bolts have been tightened, electrical and hydraulic connections are
securely connected, and that all hoses and cables have been routed safely and secured to the frame of the vehicle away
from moving parts with cable ties.
13. Final Hydraulic Install Verifications – If the vehicle requires a Hydraulic Steering Valve:
a. Clear all bystanders and start the vehicle and check for any oil leaks.
b. Adjust the Load Sense Pressure Relief Valve on the Steering Valve if the Steer Valve requires this adjustment.
14. Final Vehicle Set Up – Once the system has been fully installed, set the vehicle up in the GeoSteer system
a. Power ON the GeoSteer system.
b. Create a new vehicle profile.
c. Calibrate the vehicle.
d. If necessary, tune the vehicle to improve performance.
e. Verify the system has been installed properly and operates satisfactorily.
15. Vehicle Checklist – Fill out the Installation Checklist at the end of this Installation Manual.