Ag Leader Integra Users Manual - Manual (Page 42)

26 Firmware Version 5.4
Some Modules Not Detected
Configuration can be loaded but is not detecting all
the modules associated with the configuration. When
loaded, it will not perform the functions of the missing
modules.
Display is detecting module.
Display is not detecting module.
An example of an application configuration is shown.
The Direct Command module is detected by the
display but the Direct Injection, Crop Sensor, and
Boom Control modules are not.
Modules not the same as previously used
Configuration has a module that was not used
previously.
Module is not the one that was previously used.
If an operator selects a configuration that has a , the Module
Changed/Missing window will appear, verifying that you want to load the
configuration. If you press , the configuration will be updated with
the modules currently being used.
CIH Magnum 340, Hardi Commander 10000
CIH Magnum 340
Hardi Commander 10000
DC COM10K
Auxiliary Input Module
Liquid Control Module
Name Equipment
Container Main Tank
Device DL1
Auxiliary Input Module
Direct Injection Module: Not found
Container Injection Tank
Device Crop Sensor
Crop Sensor Master Module: Not found
Device Boom Control
Norac UC5 Controller Modu le: Not found
Vehicle
Implement
Device
Operating Configuration
JD 8235R, Appl
Equipment
Vehicle JD8235R
Implement
Name
Appl
Device DirectLiquid
Auxiliary Input Module
Liquid Control Module: Serial number does not match expected.
Container Main Tank
Operating Configuration
The selected configuration contains a
module that appears to have been replaced.
If this is the case, press accept. Otherwise,
press cancel and choose or create another
configuration.
Module Changed/Missing