HP NetStorage 6000 - Manual (Page 31)

Configuring Your System and Network
Alert Settings
3-8
SNMP/Network Management Settings
If you are using a Simple Network Management Protocol (SNMP) tool,
you can define the names of the servers to receive notification in case of a
failure.
To define the servers to receive notification:
1 Using the NetStorage web interface, click the Configuration tab, then
select Alert Settings > SNMP/Network Management.
By default, the Community String field is set to
public and the Trap
Destination fields are blank.
2 In the Trap Destination fields, enter the IP addresses or names of the
servers you want the system to notify (up to five).
3 Enter a value in the Volume Capacity Threshold field to receive a
warning message if your volume gets to a certain capacity. By default,
the field is set to 95 percent
4 Click either:
• Send SNMP Test Trap to send a cold boot test trap to the destination
addresses and save your changes.
• Apply to only save your settings.
Note The information on this screen is optional. Blank fields do not affect the
functionality of the device.