HP StorageWorks 500 Modular Smart Array - Manual (Page 49)

Hardware Options Installation
HP StorageWorks Modular Smart Array 500 System User Guide 3-5
4. Be sure that the drive LEDs illuminate one at a time and then turn off together to
indicate that the system has recognized the new drive.
In fault-tolerant configurations, allow the replacement drive to be reconstructed
automatically with data from the other drives. While reconstruction is in
progress, the online LED flashes.
Universal Hot-Plug Tape Drive Option
The MSA500 system supports the Universal Hot-Plug Tape drive (AIT and DDS-4
types) for data storage and backup. The option supports Microsoft and Novell
operating systems in various configurations.
For specific Universal Hot-Plug Tape drive configurations, refer to the HP website
www.hp.com/products/sharedstorage
When installed, the hot-plug tape drive fills two storage system hard drive bays. For
complete information, refer to the documentation that ships with the Universal
Hot-Plug Tape drive.
To install a tape drive:
1. Remove two adjacent hard drive blanks. Refer to “Removing Hard Drive Blanks”
in this chapter.
CAUTION: Installation of the tape drive height converter is permanent.
Attempting to remove the converter after installation voids the tape drive
warranty.