HP StorageWorks 500 Modular Smart Array - Manual (Page 115)

Display Messages
HP StorageWorks Modular Smart Array 500 System User Guide C-23
Table C-1: Display Messages continued
Message Type Description Action
89 INVALID VOLUME
ADDITION Error The array controller has
detected an illegal
volume addition. Remove the added volume.
90 RIS VERSION
EXCEEDED Error The array controller has
detected a version of the
RIS that it does not
support. Remove the volumes that
were added.
100 VOLUME #
STATE OK Informational The configured volume
has returned to its
normal operating state.
This condition typically
occurs after a rebuild
operation is complete. —
101 VOLUME #
STATE FAILED Error The controller failed the
configured volume
because too many
physical drives have
failed, exceeding the
fault tolerance level. The
data on the configured
volume is no longer
available. —
102 VOLUME #
STATE INTERIM
RECOVERY Informational The array controller
failed one or more
physical drives that
constitute the configured
volume.
No data loss has
occurred because fault
tolerance is allowing data
recovery.
Replace the failed drives as
soon as possible. Refer to
“Recovering from Hard
Drive Failure” in
Appendix D.
103 VOLUME #
STATE REBUILDING Informational The configured volume is
rebuilding data on a
physical drive that
replaced a previously
failed drive. —
continued