HP Surestore 6164 Switch - Manual (Page 117)

Web Tools User’s Guide 4-45
Switch View
4
SNMP Tab
Use the SNMP tab for administration of the SNMP Subsystem. From the SNMP tab you can
specify the switch community string, location, trap level and trap recipients. The SNMP tab is
shown in Figure 4-5.
Note: In order for the switches to send SNMP traps, you must first enter the Telnet command
snmpMibCapSet. This enables the MIBs on all switches to be monitored.
Config Default Select the radio button to reset the configuration to the default value.
Available in the Host Details section:
Protocol Select the pull-down menu to chose the downloading protocol.
User name Enter the User Name.
Host IP Enter the IP address of the host.
Filename Enter the filename to be downloaded.
Available in the Boot Options section:
FastBoot Select the radio button to do a Fastboot on the switch. This will allow
the switch to skip over the POST test.
Reboot Select the radio button to reboot the switch.
Power on Self-Test Check the box to have the switch do a POST test when it reboots or
uncheck the box to skip POST test for next reboot.
Reboot After
Download Check the box to have the switch reboot automatically after the
firmware download.
OK Select and exit the tab to save any changes made.
Apply Select to save any changes made to this tab and remain in the tab.
Additional changes can be made and the Apply button pressed when
making changes incrementally.
Close Select to exit the Firmware/Configuration file tab. If changes have
been made and not committed, a dialog box will display asking if
want to save the changes.
Reset Select to reset the tab to the last set of saved changes.