Create the pattern, Create the pattern 1 – Brother PE-DESIGN Ver.432 User Manual

Page 62

■

Create the pattern

The Design Page appears on the screen as shown below.

Create the pattern, making sure that it meets the following conditions.

NOTE:
If a pattern does not meet the conditions mentioned above, a warning will appear when continuing
to the next step.

With the

Optimize hoop change

setting, the actual sewing order (including the embroidery frame installa-

tion order) is optimized as explained below.
(The

Optimize hoop change

setting can be found on the Sew menu. The setting is turned on when a

check mark appears in front of the setting.)

◆

Explanation of a, b, and c:

a: Embroidering area when the

embroidery frame is installed at the
top installation position.

b: Embroidering area when the

embroidery frame is installed at the
middle installation position.

c: Embroidering area when the

embroidery frame is installed at the
bottom installation position.

The broken lines indicate each area.

◆

The size of one pattern must be no bigger
than 100

100 mm (or 130

180 mm).

(If the pattern is imported from Design
Center, only these size settings are
available.)

◆

Each pattern must completely fit within
one single area (a, b, or c).

1: This pattern is correct since it fits

completely within area a.

2: This pattern is correct since it fits

completely within either area b or
area c.

3: The size of this pattern is accept-

able, but its position must be cor-
rected since it does not fit
completely within any of the areas.

4: This pattern must be corrected

since it is too large.

◆

Specify the sewing order in the same
way that it is specified for a normal
frame.