Manual color selection – Brother PE-DESIGN Ver.432 User Manual
Page 123
113
NOTE:
When
Finish
is clicked, the expected stitch count of the pattern with the changed settings is calcu-
lated. If it is over the limit decided by the size setting of the Design Page, a message similar to this
will display.
Click
OK
to change the Photo Stitch data according to the settings made above, but normally, you
should click
Cancel
and change the value of the settings.
[Manual Color Selection]
If you click the
Edit List
button in the Photo Stitch Parameters dialog above, an Edit List dialog similar
to this will display, and you can manually set the thread colors to be used in the Photo Stitch.
In the
System Color List
, the thread colors in the color list for this software are listed in order by the
level of brightness. (Thread colors displayed in the Use Color List are not displayed in the System
Color List.)
In the
Use Color List
, thread colors selected for use in the Photo Stitch data are displayed in order
from the brightest. This order is the sewing order. The order can not be changed. The maximum num-
ber of colors that can be added to this list is 50.
From this point, the colors in the lists can be selected by clicking on them, or several colors can be
selected by holding the
key or
key and clicking on the colors.
◆
Click
Add
to add a selected color from
the System Color List to the Use Color
List. If there is no color selected, or if
the Use Color List already has 50 col-
ors, this button can not be used.
◆
Click
Remove
to delete a selected color
from the Use Color List. If there is no
color selected in the Use Color List, this
button can not be used.
◆
Click
OK
to set the edited contents of
the list and close the dialog. The edited
settings will be shown in the Photo
Stitch Parameters dialog. This button
can not be clicked when the Use List
display is empty.
◆
Click
Cancel
to close the dialog without
setting the edited contents of the list.
Shift
Ctrl