Set hole sewing – Brother PE-DESIGN Ver.432 User Manual
Page 194
184
■
Set hole sewing
Purpose:
Sets a pair of patterns for hole sewing (to avoid sewing twice at the same place
when a pattern covers another one).
Shortcut key:
No shortcut key for this function
Toolbar:
No button for this function
Operation:
1
Select a pair of patterns, for example, a rectangle included in another rectangle.
2
Click
Sew
, then
Set Hole Sewing
.
This message will display.
3
Once a pair of patterns has been set for hole sewing, they are grouped and will move together if
you try to move one of the patterns. To change their relative position, you will have to cancel hole
sewing first.
If the selected pair cannot be set for hole sewing, this message displays.
For a pair to be valid, one of the pattern must be completely enclosed within the other pattern of
the pair.
Note that you can see better what the hole sewing setting does by previewing the pair before and
after setting the pair for hole sewing (see “Preview” on page 190).
See also:
“Cancel hole sewing” on page 185
◆
Click
OK
to remove the message.
◆
Click
OK
to remove the message.
Hole sewing not set
Hole sewing set
Sewn twice
Sewn once
Valid
Invalid