To photo stitch – Brother PE-DESIGN Ver.432 User Manual
Page 119
109
Use this function to open image files in Stage 1, change them to Photo Stitch embroidery data, and then
go directly to Stage 4.
■
To Photo Stitch
Purpose:
Changes image data from Stage 1 to Photo Stitch embroidery data, and pastes
the image into Stage 4.
(This function can only be used if there is image data in Stage 1)
Shortcut key:
No shortcut key for this function
Toolbar:
Operation:
1
Prepare the image data in Stage 1. (Open, A Input from Clipboard, etc.)
2
Click
Stage
, then
To Photo Stitch
.
A Select Mask dialog similar to this will display.
In this dialog, set the boundaries of the Photo Stitch and make adjustments to the image data.
◆
Select the Mask type at the bottom of
dialog. (the Square mask is selected
when this dialog opens).
◆
Click
Image Tune
to open the Tune
Image dialog, where you can edit the
image (see below).
◆
Click
VIEW
to display a preview of only
the contents of the selected Mask on the
Design Page. The display size will be
scaled to match the Design Page size.
◆
Click
NEXT
to display the contents of
the selected Mask on the full Design
Page, and close this dialog. The
Design Size Setting dialog, used to set
the pattern size, will open next.
◆
Click
Cancel
to close this dialog and
return to Stage 1.